Series V290
CRU
Generic Type
Aliphatic Polyester Polyurethane
Common Usage
Extremely hard, chemical-resistant urethane coating with excellent abrasion resistance, wash-down conditions, corrosive fumes, and chemical contact.
View more product detailsContact your sales reps for quotes, problem solving advice, extensive technical knowledge, pricing, ordering and field support.
Curing Time
| Temperature | Min. Recoat | To Service | Chemical Resistance |
|---|---|---|---|
| 75°F (24°C) | 12 hours | 24 hours | 7 days |
Curing time varies with surface temperature, air movement, humidity, and film thickness.
Primers
Steel: Series 27, 27WB, 66, L69, L69F, N69, N69F, 90-97, 90-1K97, 104, 135, L140, L140F, N140, N140F, 161, 280FC.
Concrete: Series 27WB, 66, L69, L69F, N69, N69F, 104, 161, 201, 205, 237, 238, 280, 280FC, 281, 287.
Volume Solids
67 ± 2.0% (mixed) †
Intermediate
Series 27, 27WB, 66, L69, L69F, N69, N69F, 104, 135, L140, L140F, N140, N140F, 161, 205, 210, 222, 233, 237, 237SC, 238, 239, 239SC, 270, 273, 280, 280FC, 281, 282, 287.
Note: The maximum recoat time for Series 27WB, 210, 222, 233, 237, 238, 280, 280FC, 281, and 282 is 24 hours. Refer to those product data sheets. Inorganic zinc-rich primers require an epoxy intermediate coat. Note: Before topcoating with Series V290, any Tnemec epoxy exterior exposed for more than three weeks must be scarified or reprimed with itself. Note: Scarification using a power sander and 100 grit sandpaper, No. 60 mesh sanding screen or a coarse stripping pad is required if topcoating Series V290 with itself. Mechanically abrading or power-sanding is the preferred method of scarification. Note: Common practice is to thoroughly scarify smooth, glossy surfaces prior to applying Series V290. Note: When applying Series V290 over a broadcast or mortar system, an epoxy grout coat is required.
Theoretical Coverage
1,075 mil sq ft/gal (26.4 m²/L at 25 microns). See APPLICATION for coverage rates. †
Volatile Organic Compounds
Unthinned: 2.01 lbs/gallon (241 grams/litre).
Thinned 20% (No. 49 Thinner): 2.01 lbs/gallon (241 grams/litre) †
Finish
Semi-Gloss
HAPS
Unthinned: 0.019 lbs/gal solids
Thinned 20% (No. 49 Thinner): 0.019 lbs/gal solids
Recommended DFT
2.0 to 3.0 mils (50 to 75 microns) per coat. Note: Number of coats will vary depending on substrate (surface) and other variables. Contact your Tnemec representative.
Number of Components
Two: Part A and Part B (2.5 Parts A to 1 Part B by volume)
Still have questions? Request the information you’re looking for:
Request InfoHow to Purchase
Tnemec coatings are sold through a select network of local independent sales representatives who can help you find the best product for your needs. Find a rep